Furnace & heating
AC repair
Heat pumps
Ductless mini splits
Carrier
Trane
GoodmanSeasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Get your free estimateFast, Reliable Furnace Repair Across Kyle
Furnace repair in Kyle typically runs $150 – $700, and most no-heat calls can be diagnosed the same day. If your furnace is blowing cold air on a 30°F night, you don’t need a four-hour window or a callback tomorrow. You need a technician at your door with a written price before a single tool comes off the truck. Halden Heating and Air Austin runs crews across Kyle every day, from Plum Creek to Waterleaf to the older sections off Center Street. Call (361) 202-9170 and you’ll talk to a real person, not a voicemail tree.
Why Halden Heating and Air Austin Is Kyle’s Preferred Furnace Repair Company
Kyle homeowners deal with a very specific set of furnace problems, and we’ve seen nearly all of them. The newer subdivisions here grew fast. Homes went up in months, not years. That speed shows up later in the HVAC equipment: builder-grade furnaces paired with undersized ductwork, static pressure built too high for the blower motor to survive, and equipment installed in attics that hit 140°F in July. When we roll into Kyle, we already know what to check first. That local knowledge means fewer wasted trips, faster diagnostics, and parts replaced only when they actually failed.
Andre Fuller leads our service team, and every repair we complete in Kyle includes a written guarantee. That’s not a sales pitch. It’s a term of service. If the repair fails within the coverage window, we return at no charge. No arguing, no fine print, no phone tag. You also get a written price before any work starts, along with a live arrival time you can track on your phone, the same way you’d track a rideshare. We’re background-checked, uniformed, and we service Trane, Lennox, Goodman, and Rheem furnaces throughout Hays County.
Styles & brands we work with
Boiler Repair in Kyle
Boiler Repair in Kyle is less common than furnace repair, but we handle it for the older homes and a small number of newer custom builds that use hydronic heat. A boiler heats water and pushes it through radiators or baseboard units, and when it fails, you lose heat everywhere at once. Most boiler repairs in Kyle fall between $150 and $700, depending on the part. We check the circulator pump, the expansion tank, the thermocouple on older gas boilers, and the pressure relief valve. If the boiler is short-cycling or making a rumbling noise, that usually points to scale buildup or trapped air in the lines.
Circulator Pump and Zone Valve Failures
In older Kyle homes with zoned heating, a single failed zone valve or circulator pump cuts heat to one part of the house while the rest stays warm. We test each zone independently and replace only the failed component. Some homes here still run original 1980s pumps, and by now the impellers are worn or seized.
Heat Exchanger Inspection on Boilers
If you smell a faint metallic odor or see soot around the boiler cabinet, we inspect the heat exchanger for cracks. A cracked heat exchanger on a boiler can release carbon monoxide into the home. We’ll shut the unit down and give you a straight answer on repair versus replacement before you spend a dollar.
Gas Furnace Repair in Kyle
Gas Furnace Repair in Kyle covers the majority of what we do in the winter. Most homes here run natural gas furnaces from Trane, Lennox, Goodman, or Rheem, and most calls come in on the first cold snap of November or December. Typical gas furnace repair in Kyle runs $150 – $700. The most common culprits are failed ignitors, dirty flame sensors, cracked heat exchangers, gas valves that won’t open, and blower motors that overheat and lock out. We diagnose the exact component, quote you a fixed price, and typically complete the repair the same visit.
Ignitor and Flame Sensor Diagnosis
A furnace that tries to start but never lights usually has a cracked ignitor or a flame sensor covered in carbon. If you hear the gas click on and then shut off after a few seconds, tell us over the phone. That small detail helps us stock the right part before we leave for your home. We carry common ignitors and sensors for Lennox, Goodman, and Trane units, so most repairs don’t need a second trip.
Gas Valve and Control Board Checks
When the furnace does nothing at all, we work through the control sequence: thermostat signal, pressure switch, gas valve, and board. We don’t swap parts hoping something works. We test each component and show you what failed before quoting a repair.
Trusted Brands We Service in Kyle
We repair Trane, Lennox, Goodman, and Rheem furnaces throughout Kyle, and our techs are certified to service all three. Because we run a high volume of repair calls in Hays County, we stock the most common Trane ignitors, Goodman control boards, and Lennox blower capacitors on our trucks. That means fewer “we’ll order the part and come back next week” conversations. Most Kyle furnace repairs are completed same-day because we show up with the parts your system actually uses, not a generic kit that might fit.
Common Furnace Repair Problems We See in Kyle Homes
- Blower motor capacitors baked by unvented attics. In Plum Creek and Waterleaf, many furnaces sit in attic spaces that exceed 140°F during summer. Capacitors are rated for far less. We replace capacitors that read weak before the blower motor seizes on the first freezing night.
- Undersized ductwork choking newer furnaces. Homes built in the 2000s through 2020s often got furnaces sized by rule of thumb, not load calculation. When the return duct can’t supply enough air, static pressure climbs and the blower motor burns out in a few winters. We measure static pressure on every no-heat call.
- Heat pump coils freezing in all-electric homes. Kyle has entire subdivisions without natural gas service. These homes run heat pumps year-round, and winter cold snaps freeze the outdoor coil when airflow is restricted. A dirty filter alone can do it. We thaw the coil, check the refrigerant charge, and fix the root cause.
- Control boards that fail by year five. Constant attic heat and our on-again, off-again winter nights put real stress on furnace electronics. We see failed boards in furnaces less than six years old, especially in the rapid-build neighborhoods where contractors installed equipment during summer heat waves.
See the difference
Before
After
Before
After
Before
AfterPricing for Furnace Repair in Kyle, TX
Every furnace repair in Kyle gets a written price before we touch the unit. Not an estimate range we might revise later. A locked number, in writing, approved by you first. Here’s what that looks like in the Kyle market:
| Repair Type | Typical Price Range |
|---|---|
| Furnace Repair | $150 – $700 |
| Gas Furnace Repair | $150 – $700 |
| Boiler Repair | $150 – $700 |
Lower-end repairs are things like flame sensors, ignitors, and capacitors. Higher-end repairs involve blower motors, gas valves, or control boards. If the repair fails within your guarantee window, we return free. That’s part of our 365-Day Done Right Promise, not an add-on. Call (361) 202-9170 for a free estimate.
We Also Serve Cities Near Kyle
Our Furnace Repair team runs calls through Kyle and the surrounding communities daily. You’ll find us in Buda, Lockhart, Manor, and down into Austin. Same written pricing, same live arrival time, same guarantee. If you’re just outside Kyle city limits, call us and we’ll confirm we can reach you fast.
Serving Kyle, TX - Our Local Coverage Area
We’re based in the Kyle area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Furnace Repair in Kyle
High static pressure from undersized ductwork in tract homes built between the 2000s and 2020s is the main reason. When the duct system can’t move enough air, the blower motor works harder than it was designed to, overheats, and fails. We measure static pressure before replacing any blower motor. Fix the airflow and the new motor lasts. Skip the airflow fix and you’ll replace the motor again in a few winters. Call (361) 202-9170 if your furnace has already eaten one blower motor.
That usually points to a dirty blower wheel, a clogged filter, or an undersized return. In Kyle homes built around 2018, the return drop is often too small for the furnace, and the heat exchanger runs too hot trying to push air through a restrictive duct system. We check airflow and static pressure first, before condemning the furnace itself. Call us and we’ll give you a written diagnosis, not a guess.
A banging noise at startup often means the ductwork is oil-canning as pressure builds, but it can also point to a delayed ignition in the heat exchanger. Delayed ignition means gas is pooling instead of lighting immediately, and that can be dangerous. If your older Kyle furnace bangs consistently at startup, shut it down and get a technician out before the next cold night. Call (361) 202-9170 and we’ll inspect the burner assembly and heat exchanger.
Most new Trane, Lennox, Goodman, and Rheem furnaces in Kyle carry a 10-year parts warranty, but only if the homeowner registered the unit within 60 days of install. Unregistered units drop to a 5-year base warranty. Labor is almost never covered. We see Kyle homeowners find this out the hard way when a control board fails at year six. We can look up your warranty status and tell you, in writing, what the repair will cost after warranty credit. Call (361) 202-9170 with your unit’s serial number.
Your heat pump’s outdoor coil freezes when airflow is low or refrigerant charge is off. Kyle’s winter mornings, especially in the Hill Country transition zone, bring just enough cold and humidity to ice a coil overnight. A dirty filter or a clogged return does it too. We defrost the coil, check the charge and airflow, and fix whatever triggered the freeze so it doesn’t come back next cold snap.
Call Halden Heating and Air Austin for Furnace Repair in Kyle
When your furnace goes down in Kyle, you want a real person on the phone, a technician you can track, and a written price before work starts. That’s how we run every call. Book online or call (361) 202-9170 now for a free estimate. We answer 24/7, we serve all of Kyle and the surrounding Hays County communities, and every repair is backed by our 365-Day Done Right Promise.
Written by Andre Fuller, Owner at Halden Heating and Air Austin, serving Kyle and surrounding communities.